Cresswater Solutions
18 Forcefield Road
Cullompton
Devon, EX15 1QB
Tel: 01884 839000 - Mob: 07771 750687

ABOUT REED-BEDS:

Two different types of reed-beds have been developed and used for the treatment of polluting waste water effluents over the last 30 years or so:

  • Horizontal flow reed beds
  • Vertical flow reed beds

HORIZONTAL FLOW REED BED SYSTEMS

Free Water Surface and Sub-Surface Horizontal Flow reed beds work particularly well for low strength effluents, or effluents that have undergone some form of pre-treatment.

Whilst not effective in reducing ammonia they will almost always reduce BOD (Biochemical Oxygen Demand) and SS (Suspended Solids) levels. These systems play an invaluable role in tertiary treatment and the polishing of effluents, and as a safeguard against shock loadings.

A typical application would be to treat the discharge from a package sewage treatment plant which is unable to meet the discharge consent standard required on its own.

VERTICAL FLOW REED BED SYSTEMS

Vertical flow reed-bed systems are much more effective than horizontal flow reed-beds not only in reducing BOD and SS levels but also in reducing ammonia levels and eliminating smells. Smaller than horizontal flow beds they are capable of handling much stronger effluents and have a longer lifetime value.

We use constructed wetland systems for primary and secondary treatment of sewage and stronger wastewaters. They have a particular role in the nitrification of effluents - the removal of ammonia.

We have specialised in the use of vertical flow reed-beds for more than 20 years. They take up less space, are highly effective and easy to maintainn.

 

FORCED BED AERATION REED-BEDS

For the treatment of strong effluents and where space is limited Forced Bed Aeration (FBA™) technology significantly increases the performance of both vertical flow reed-beds and horizontal flow reed-beds. Developed in the USA by Naturally Wallace this highly effective technology has been in use for more than 15 years. Through our licence agreement with ARM Ltd we have access to a large body of information and expertise in the application of this technology that has been built up over that time.

COMBINATION SYSTEMS

Multi-stage reed-bed systems, incorporating one or two stages of vertical flow followed by one or more stages of horizontal flow, or large single stage vertical flow reed-beds, when properly designed, are used, for example, for the full treatment of domestic sewage - black and grey water - and sludge, if required.

TYPICAL FEATURES OF A COMBINATION REED-BED SYSTEM WITH TWO DOWNFLOW STAGES AND ONE HORIZONTAL

 

CRESS WATER SOLUTIONS’ reed-bed systems can be designed to accommodate virtually any situation - from flat sites to steep rocky slopes. On sloping sites gravity can be used, whereas one or two pumping stages may be required on flat sites, to move the effluent through the reed-beds.

Reed-bed systems do not require a lot of space. The most effective “combination reed-bed systems”, usually sized at 2.5 - 3.0 sq.m. per person equivalent for sewage treatment, have a remarkably small footprint.